Power Price in Pakistan
Showing 49–72 of 152 results
- Diagnostic Tools, Power, Tools
Computer Power Supply ATX Tester Debugger
- ATX 20, 24 PIN Tester
- Voltage Source: 20/24 PIN (ATX Connector)
- Green Indicator light=Power is OK
- VOLTAGE TEST:+12V,-12V +5V,-5V +3.3V, 5V STAND BY(SB), POWER GOOD(PG)
- Easy use ,the operation instruction on the face of tester
- Connectors: Floopy, HDD, CDROM, SATA, 4PIN(P4), 8PIN, 6PIN
- Plug & Diagnose
SKU: n/a - Components, IC, Power, Voltage Converters
AP8012 OFF Line SMPS Primary Switcher Power Management IC
- The AP8012 combines a dedicated current mode PWM controller with a high voltage power MOSFET on the same silicon chip.
- 9v to 38v wide range VCC voltage
- Fixed 60KHz switching frequency
- Automatic skip cycle mode in low load condition.
- Over temperature, over current and over voltage protection
SKU: n/a - Components, IC, Power, Voltage Converters
SD6834 PWM PFM Power Management IC
- SD6834 is current mode PWM+PFM controller with built-in high-voltage MOSFET used for SMPS.
- It features low standby power and low start current. In standby mode, the circuit enters burst mode to reduce the standby power dissipation.
- The switch frequency is 25~67KHz decided by the load with jitter frequency for low EMI.
- Built-in peak current compensation circuit makes the limit peak current stable even with different input AC voltage.
- Maximum peak current compensation during power-on reduces pressure on transformer to avoid saturation, the peak current compensation will decrease for balance after power-on.
- Limit output current can be adjusted through the resistor connected to CS
SKU: n/a - Diagnostic Tools, Power, Tools
Mini PCI/PCI-E LPC Tester Diagnostic Debug Card Adapter For Notebook Laptop
Diagnostic Tools, Power, ToolsMini PCI/PCI-E LPC Tester Diagnostic Debug Card Adapter For Notebook Laptop
- 3 in 1 Mini PCI / Mini PCI-E / LPC diagnostic card with 2-digit code for notebook
- Great for IT enthusiasts and engineers to test and repair computer
- It can diagnosis the motherboard signal which show the problem of CPU, Memory, Display, etc.
- PC Motherboard Diagnostic Card
- High Quality Build
SKU: n/a - Modules, Power, Voltage Converters
DC-DC 300W 9A Step Down Buck Converter CC-CV
- Color: as the pic shows
- Input voltage: 5-40V
- Output voltage: 1.2-35V (continuously adjustable)
- Output Current: 9A (if temperature exceeds 65°C please add cooling fan)
- Constant current range:0.2-9A ( adjustable )
- Output Power: Maximum power is about 300W (if temperature exceeds 65°C please add cooling fan)
- Size: Approx. 2.55*1.88*0.94inch / 6.5*4.8*2.4cm(Length*width*thickness)
SKU: n/a - Modules, Power, Relays
Automatic Street Light On Off Photo Sensor Control Switch 220V 10A
- This Switch can be used to Automatically Turn ON & OFF Street Light & Garage Lights Based on Sun light Intensity
- For example It will turn on the lights when there is no sun light detected in the evening.
- It will automatically turn off the lights early in the morning when the sunlight detected.
- Power Saving & Energy Efficient Device
- This device Have some other uses as well.
- For example if you are using Wapda & Solar Power, You can cut off Wapda Load from UPS & Automatically Switch to Solar Energy
- When the Sunlight detected it means Solar Power is available (It kills Wapda Power & Switch to Solar Power)
- When the Sunlight not detected, that means the Solar Power is not available (It will Restore Wapda Power to UPS)
- It has built in Relay Module Which Supports 220V & 10A (Ideal Load for average Home UPS)
SKU: n/a - Power, Voltage Converters
Dual USB 18650 Battery Charger Module for Power Bank
- Motherboard comes with protection function: Charging overcharge protection,
- Over-discharge protection, overcurrent protection.
- Intelligent output device after charging full, automatically stop charging, to prevent mobile phones overcharge.
- Output voltage and current stable, will not harm user devices.
- Micro USB input: 5V 1A
- USB Output: 5V 2.1A / 5V 1A(Dual USB interface)
- Charging display: intelligent digital display
- Batteries Type: liquid lithium-ion batteries (18650) or any other 3.7-4.2v Batteries
- Product Size: 57mm x 28mm
- Screen size:27mm x 17mm
SKU: n/a - Arduino, Robotics
S30K DC 12V 14RPM High Torque Geared Reduction Motor
- Gear Reduction has a large Torque & Small Noise.
- Suitable for Electric Toys, Handicrafts, Rotating Table Box, DC Shaking Head Fans, Display, etc.
- By changing the sign of the motor wiring you can change the rotation direction of the motor.
- Voltage: DC12V
- Load Speed: 14R / min
- Output Torque: 1.2kg*cm
- Very Very Powerfull (You can not stop it with hand while its rotating)
SKU: n/a - Modules, Power, Relays
XH-M603 Charge Controller Protection Module With LED Display
XH-M603 is a Charging Control Module 12-24V with Protection from Overcharging
- XH-M603 is ideal solution for Solar Panel & Battery
- Connect your Solar Panel or Charger on In+ & In-
- Connect Battery on BAT+ & BAT- (Lithium or Lead Acid)
- This Module protects your battery from Overcharging & Overheating
- It will extend the life of your battery
- This Module can operate on either 12V Single Battery or 24V Dual Battery
SKU: n/a - Modules, Power, Voltage Converters
0.9V 3V 5V to 5V 600MA USB Output Charger Module
- Input Voltage: 1-5V
- Output Voltage: 5.1-5.2V
- Output Current: Rated 600MA
- Efficiency:: Up to 96%
- Works with all types of Lipo & Lithium batteries for example 18650 bl5c bl5b
- Charge cellphone or power up your USB Gadgets
SKU: n/a - Arduino Components, Modules, Power, Relays, Robotics
LED Display Automatic Cycle Delay Real Time Clock RTC Control Relay
Arduino Components, Modules, Power, Relays, RoboticsLED Display Automatic Cycle Delay Real Time Clock RTC Control Relay
- Operating voltage: 5.0V ~ 60V
- Support MicroUSB 5.0V Power Supply
- Trigger Source: Active-high (3.0V-24V),
- Output Capability: You can control the DC 30VDC 5A or 220VAC 10A device.
- Quiescent Current: 20mA; Operating Current: 50mA
- Life: more than 10 million times; Working temperature: -40-85
- This Module can be used to specifically Turn On / Turn Off an Electrical appliance on Specific Time for the specific duration
- This is Advanced Cyclic Timer Relay Module with Timer Clock function as well
SKU: n/a - Diagnostic Tools, Power, Tools
PCI Slot Motherboard Tester Diagnostic Debug Card Adapter For PC
- Intercept and hex the code of your booting computer.
- Hexadecimal character display.
- With 4 LED indicator.
- Detailed & precise LED function table and code Indication table, convenient for you consulting.
- Material: Plastic + Metal
- Main Color: Green
- Size: 6.3×4.7cm/2.48×1.85in (Approx.)
SKU: n/a - Arduino Components, Modules, Power, Tools
Digital Panel Voltmeter 0.36 LED Display 0-100V DC
- Type: 3-Wire Car Digital Voltmeter
- Material: Plastic
- Operating Voltage: DC 2.5-30V
- Operating Current: <20mA
- Measure Voltage: DC 0-100V
- Minimum Resolution: 0.1V / 0.01V
- Display: Red color, three digit, 0.36″
- Refresh Rate: About 200mS / times
SKU: n/a - Modules, Power, Relays
XH-M131 12V LDR Photoresistor Light Control Relay Module
- Light threshold can be adjusted by potentiometer to set the relay start
- Input: 12V DC
- Load capacity: 10A / AC 250V or DC up to 30V
- Size: 30MM*53MM
- Uses
- This can be used to control the light automatically by detecting the day light.
- This Module can be used to kill the WAPDA Power supply to UPS in Solar Power Environment
SKU: n/a - Charge Controller, Modules, Power, Relays
XH-M601 Battery Charging Protection Module
- Model: XH-M601
- Power Supply: 13.8V-14.8V
- Relay closing voltage: 12.4V
- Relay off voltage: 14.8V
- Voltage error:±0.1V
- Voltage detection: DC voltmeter
- Charging type: 12V battery
- Potentiometer adjustment: RP1 RP2 (carefully adjusted)
SKU: n/a - Modules, Power, Voltage Converters
LTC1871 High Power 100W Digital Display Stepup Boost Module
The boost module uses advanced microcontroller and U.S. imports boost controller, it eliminates the need for a current sense resistor by utilizing the power mosfet’s on-resistance, thereby maximizing efficiency, up to 96.4%. Imported high-power low-resistance mos transistor, heavy current and high efficiency schottky, wider and thicker PCB traces, is a guarantee of high-power and low temperature rise. When the input and output voltage is greater than 20V, the module up to 128W output power.
SKU: n/a - Arduino, Arduino Components, Modules, Power, Robotics
NE555 PWM Pulse Signal Generator
- Used as a square wave signal generator
- offer the square wave signal for the use of the experimental development.
- Used to produce driving stepper motor drives, offer the square wave signal.
- Adjustable pulse for the use of MCU.
- Generate pulse with adjustable frequency & duty cycle.
SKU: n/a - Modules, Power, Voltage Converters
XL4016 DC-DC 200W 8A Step Down Buck Converter
- Input voltage: DC 4-38V
- Output voltage: DC 1.25-36V
- Maximum current: 8A
- Maximum power: 200W
- Conversion efficiency: 95%
- Working Temperature: -45~+85℃
- Size: 6×3.7cm/2.36×1.46inch
- Voltage Regulating Mode: PWM Modulation
- Switching Frequency: 180KHz
SKU: n/a